Enabling DLM
Taking DLM into use for your Sites is really simple! By following the next steps you have DLM enabled in a couple of minutes.
Enabling multi-level DLM can be done by following the instructions below on every related site that you want the DLM to be applied to. DLM follows the site structure, so by applying configurations to both parent and subsites you can create a more complex DLM setup.
1. Click "DLM" under Site
2. Click "Configure" to start DLM configuration
3. Set the Max current and Earthing system for your DLM configuration. Make sure that the Max current doesn't exceed available fuse capacity.
4. After initial configuration if all your chargers are available, you can activate the DLM. Click "Activate" to set DLM active. After DLM has been activated, you can see the status of the individual sockets below. Total amperage used by the DLM site is also visible.
5. eMabler DLM also supports external meters. If you want to add external metering to your DLM configuration, click "Add external metering"
6. If you want to disable DLM for your site, you can click "Disable".
